Wholesale of suspended pesticide applicators

Release time：2023-09-13    Click：218

When the hanging type pesticide applicator starts to be used, we need to conduct a comprehensive inspection. This inspection requires checking every place, and regardless of whether it has any faults before use, as long as it is used, it must be checked before and after use. Below, the editor will briefly introduce it to everyone:

1. Inspection before use of the dispensing machine

According to the requirements of the engine, check the oil level to ensure sufficient lubrication. Inspection of gearbox oil. Have each filter been cleaned thoroughly? If there is dirt, it will not only affect the normal operation of the machine, but also increase the pressure on the nozzle. And whether the clamps that fasten the pipes in each place are loose. It is also necessary to check the tire pressure, and the inflation pressure should be at 120Mpa.

2. Dosing machine with water

Before starting the medicine dispenser, it is necessary to directly add water through the filter screen at the mouth of the medicine box.

3. Dispenser dosing

Before spraying, the drugs need to be fully mixed and stirred. First turn off the switch of the spray pipeline, and the tractor drives the spray machine to run for 5-10 minutes before mixing. If liquid pesticides are used, they should be added directly from the top of the medicine box. When using powdered pesticides, it is necessary to first dissolve them with water and then add them to the medicine box to stir. Therefore, before adding pesticides, it is necessary to know whether the pesticides you are using are liquid, solid, or powdered.

Before and after using the hanging pesticide applicator, we hope everyone can pay attention to these, as a complete inspection is a basic prerequisite to ensure its normal operation. We hope everyone will remember this point